Moving Your Cooker - Falcon 900 DL Mode D'emploi & Instructions D'installation Et D'entretien

Cleaning Brass Components
Uncoated natural brass is used as part of the
authentic finish and may tarnish with age.
To regain a polished finish, these areas should be
cleaned using a proprietary cleaner .
Main Oven
The shelf supports on the oven sides can be
removed for cleaning.
To refit the side support, first
locate the tag at the bottom of
the support in the slot in the
locating bracket in the oven side.
Then locate the tops of the side
arms in the holes at the top.
The panels on the oven sides are fixed and cannot
be removed. They have been coated with special
enamel that partly cleans itself.
This does not stop all marks on the lining, but helps
to reduce the amount of manual cleaning needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below this
temperature, occasionally remove the shelf supports
and wipe the panels with a lint free cloth and hot
soapy water. The panels should then be dried and
the oven heated at 200°C for about one hour. This
will ensure the Cook & Clean panels are working
effectively.
Don't use steel wool (or any other materials that will
scratch the surface). Don't use oven cleaning pads.
All manuals and user guides at all-guides.com
First remove the oven
shelves then pull the
top of the shelf support
up and away from the
oven side and then lift
the support away from
the locating bracket in
the oven side at the
bottom.
14
The Tall Oven
To clean the oven sides slide out the shelves, unhook
the supports from the oven sides and lift out.

Moving your cooker

Switch off the electricity supply.
The cooker is heavy; two people may be required
to move it.
There are two levelling rollers at the back and also
two screw down levelling feet at the front.
Open the grill door and right hand oven door so that
you can get a good grip on the bottom of the fascia
panel as you move the oven.
Lift the front of the cooker slightly and pull forward.
Do not move the oven by pulling the handrail,
door handles or knobs.
Move the oven a bit at a time, checking behind it to
make sure the gas hose is not caught. Make sure
both electricity and gas cables have sufficient slack
to move the cooker forward as you go along.