Control Panel And Oven Doors - Falcon 900 DL Mode D'emploi & Instructions D'installation Et D'entretien

After the cooking surface cools down and the
heat indicator lights go off, use the daily care
procedure as outlined above.
Cleaning for burned-on spills
In the unlikely event that food has burnt onto the
surface of your induction hob, be sure that the heat
indicator lights are off and the hob is cool. Remove
excess burned-on substance with a ceramic hob
scraper. Hold the scraper at approximately a 30°
angle to the surface and scrape off the burned-on
matter.
IMPORTANT: Take care when using a sharp
scraper. When you have removed as much as
possible with the scraper clean using the daily
care procedure as described above.
Glide-Out™ Grill
Before you remove any of the grill parts for
cleaning make sure they are cool.
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods that
soil, leave to soak for a few minutes in the sink
immediately after use. Stubborn particles may be
removed from the grid by using a nylon brush.
Alternatively the grill pan can be washed in a dish
washer.
To remove the grill pan support frame, pull the grill
pan forward.
Lift the grill pan clear of the support frame.
The support frame is held to the side rails by two
clips on each side.
All manuals and user guides at all-guides.com
13
For each side, support the side rail with one hand
and with the other hand lift up and out of the side
clips.
For safety, push the side rails back into the grill
chamber. The side rails can be removed to make
cleaning the grill chamber easier by unhooking them
from the grill chamber sides.
Slides can be wiped clean with a soft cloth and mild
detergent.
DO NOT use any abrasive substance.
DO NOT put the side runners in the dish washer.
When you have finished, hook the side rails back
on to the sides of the chamber. To refit the frame
pull the side rails forward and for each side in turn,
support the side rail and press the frame down in to
the side rails. Replace the grill pan.

Control Panel and Oven Doors

For best results gentle liquid detergents should be used.
The control panel and control knobs should only be
cleaned with a soft cloth wrung out in clean hot soapy
water - but take care that no surplus water seeps into
the appliance. Wipe with a clean dampened cloth
then polish with a dry cloth. The oven doors should
only be cleaned with a soft cloth wrung out in clean
hot soapy water.