Troubleshooting - Falcon 900 DL Mode D'emploi & Instructions D'installation Et D'entretien

If a stability chain is fitted, release it as you ease
the cooker out. Don't forget to refit it when you
replace the cooker.
When you replace the cooker, again check behind to
make sure that the electricity and gas cables are not
caught or trapped.
All manuals and user guides at all-guides.com
15

Troubleshooting

Interference with and repairs to the hob by
unqualified persons are not allowed. Do not try
and repair the hob as this may result in injury and
damage to the hob. Please arrange for repair by a
competent person.
Please note:
The induction hob is also able to self diagnose a
number of problems and can display this information
to the user via the hob control display. Error codes
may be displayed if your hob has developed a fault:
If your appliance reports an error or is not working,
you may be able to rectify the fault by consulting
these instructions for use.
Error Code E2 is displayed.
The electronic unit is too hot. Please check the
installation of the range, make sure that there is
sufficient ventilation. In extreme cases if you have
allowed a cooking utensil to boil dry, this error code
may also be displayed.
If in doubt please consult your installer or a qualified
repair engineer.
Error Code U400 is displayed.
The hob/range has been incorrectly connected. The
control will switch off after approximately 1 second
and the error code will be permanently displayed.
Consult your installer or a qualified repair engineer.
Error Code ERxx or Ex is displayed.
The appliance has developed an internal technical
fault that cannot be rectified by the user.
Please consult your installer or a qualified repair
engineer
The fuse blows or RCD trips regularly.
Please consult your installer or a qualified repair
engineer.
You cannot switch your induction Hob on?
Has the wiring system in the house blown a fuse or
tripped an RCD?
· Has the hob been correctly connected to the
mains supply?
· Has the child lock function been activated, please
refer to the instructions for use section about this
function.
Are you using suitable cookware, please refer to the
instructions for use section about selection of the
correct cookware.