Télécharger Imprimer la page

Electrical Connection; Oven Check - Falcon 900 DL Mode D'emploi & Instructions D'installation Et D'entretien

Publicité

Les langues disponibles

Les langues disponibles

Open the grill door and the Tall oven door. Grip under
the facia panel and lift the front of the cooker.
Carefully push the cooker backwards close to its final
position leaving just enough space to get behind it.
Take care not to damage the power cable.
Levelling
You are recommended to use a spirit level on a shelf
in one of the ovens to check for level.
Place the cooker in its intended position taking care
not to twist it within the gap between the kitchen units
as damage may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to
level the cooker. To adjust the height of the rear of
the cooker use the levelling tool supplied to turn
the adjusting nuts at the front bottom corners of the
cooker. To set the front feet turn the bases to raise or
lower.

Electrical Connection

This appliance must be installed by a qualified
electrician to comply with the relevant regulations
and also the local electricity supply company
requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct
electrical supply as stated on the voltage label on
the cooker, through a suitable cooker control unit
incorporating a double pole switch having a contact
separation of at least 3mm in all poles. This cooker
must not be connected to an ordinary domestic
power point.
The total electrical load of the appliance is
approximately 16.55kW.
All manuals and user guides at all-guides.com
Do not use the door
handles or control knobs to
manoeuvre the cooker.
Use the hotplate and griddle
bowl areas.
Remove the pack base tray.
The cable size used should be suitable for this load
and comply with all local requirements.
Access to the mains terminal is gained by removing
the electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for
your electrical supply type.
Check that the links are correctly fitted and that
the terminal screws are tight.
Secure the mains cable using the cable clamp
Grill
Open the grill compartment door. Turn on the grill
control and check that the grill heats up.

Oven check

Turn on the ovens and check that they start to heat
up. Turn off the ovens.
18
..

Publicité

Chapitres

loading