Unpacking The Cooker; Moving The Cooker - Falcon Toledo XT Instructions D'utilisation Et D'installation

For safety reasons curtains must not be fi tted im me di ate ly
behind the cooker.
We recommend a gap of 1110mm between units to allow
for moving the cooker. Do not box the cooker in; it must still
be possible to move the cooker in and out for cleaning and
servicing.
A clearance of 130mm is required if the cooker is near a
corner of the kitchen to allow the oven doors to open. The
actual opening of the doors is slightly less but this allows for
some protection of your hand as you open the door.

Unpacking the Cooker

Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not fi t
through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off the
cooker, leaving the cooker standing on the base packaging.
See the loose unpacking sheet.

Moving the Cooker

The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure
that the fl oor covering is fi rmly fi xed, or removed to prevent
it being disturbed when moving the cooker around. You will
need the levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack.
Repeat from the front and remove the front half of the poly
base. Pull the drawer out to its furthest point.
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
INSTALLATION
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at
the same time pull the drawer forward and away from the
side runners. For safety's sake push the drawer runners back
out of the way. Put the drawer somewhere safe - do not refi t
it until the installation is complete.
Lower the Rollers.
Fit the Allen key tool to the centre roller lowering
mechanism (C in the fi g. below).
A left rear roller, B right rear roller, C centre roller
LOWER THE FRONT ROLLER by doing 14 complete (360°)
turns clockwise.
Now LOWER THE TWO REAR ROLLERS.
First fi t the levelling tool on the hexagonal adjusting nut as
shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
45