The Griddle; The Wok Cradle - Falcon Toledo XT Instructions D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Turn the knob towards it after the contents of a pan have
boiled
Make sure fl ames are under the pans. Using a lid will help
the contents boil more quickly.
Pans and kettles with concave bases or down turned base
rims should not be used.
Simmering aids, such as asbestos or mesh mats, are NOT
recommended. They will reduce burner performance and
could damage the pan supports.
Avoid using unstable and misshapen pans that may tilt
easily and pans with a very small base diameter e.g. milk
pans, single egg poachers. The minimum pan diameter
recommended is 120mm.
The maximum pan base diameter is 250mm.
The Wok burner is designed to provide even heat over
a large area. It is ideal for large pans and stir frying. For
heating smaller pans the smaller burners may be more
effi cient.
If a burner fl ame goes out, turn the control knob off and
leave it for one minute before relighting it.
You can remove the burner parts for cleaning, see the
'Cleaning your cooker' section of the instructions.
You should wipe the enamel top surface of the cooker
around the hotplate burners as soon as possible after spills
occur. Try to wipe them off while the enamel is still warm.
Note:
Use of aluminium pans may cause metallic marking of the
pan supports. This does not aff ect the durability of the
enamel and may be cleaned off with a proprietary metal
cleaner.

The Griddle

The griddle fi ts a single pan support, front to back.
It is designed for cooking food on directly. Don't use pans
of any kind on it. The griddle surface is non-stick and metal
cooking utensils (e.g. spatulas) will damage the surface. Use
heat resistant plastic or wooden utensils.
Don't put it crossways - it will not fi t properly and will be
unstable.
Don't put it on the Wok burner - it is not designed to fi t the
Wok burner pan support.
Position the griddle over the hotplate burners resting on
the pan support. The griddle can be lightly brushed with
cooking oil before use. Light the hotplate burners. Adjust
the fl ame heights to suit.
Preheat the griddle for a maximum of 5 minutes before
adding food. Leaving it longer may cause damage. Turn the
control knobs towards the low position, marked with the
small fl ame symbol, to reduce the burner fl ames.
Always leave space around the griddle for the gases to
escape. Never fi t two griddles side by side. Large pans
should also be spaced well apart.
Experience will soon familiarise you with the correct setting
to use for cooking.
After cooking allow the griddle to cool before cleaning.

The Wok cradle

The Wok cradle is designed to fi t a TyphoonTM Professional
35cm Wok (Part Code 13840S)
This is available from leading retailers.
If you use a diff erent Wok make sure that it fi ts the cradle.
Woks vary very widely in size and shape. It's important that
the Wok sits down on the pan support - but if the Wok is too
small the cradle will not support it properly.
The cradle should be used on the triple ring Wok burner
only.
When you fi t the cradle check that it is properly located on
the pan support fi ngers and that it is stable. Make sure the
Wok is sitting level in the ring.
The cradle will get very hot in use - allow plenty of time for it
to cool before you pick it up.
31
English

Publicité

Chapitres

Table des Matières
loading

Table des Matières