Transport; Set-Up; General Information; Condensed Water Pipe - Dimplex LA 9K Instructions D'installation Et D'utilisation

4
4

Transport

ATTENTION!
When transporting the heat pump, ensure that it is not tilted more than
45° (in any direction).
Use the wooden pallet for transporting the heat pump to its final
installation location. Either a lift truck or 3/4" pipes fed through
the holes in the base plate or frame can be used for transporting
the heat pump.
ATTENTION!
The heat pump and transport pallet are only joined by the packing film.
To avoid injuring your hands, ensure that the 3/4" pipes cannot
slip when being used to lift the pump.
When inserting the pipes through the frame, ensure that the com-
ponents are not damaged (especially the plastic condensate tray
and/or the drain stubs).
E-4
All manuals and user guides at all-guides.com
5

5.1 General Information

The device should always be installed on a permanently smooth,
even and horizontal surface. To counteract development of any
solid-borne sound, the entire frame (and its supporting surface)
should be in contact with the floor. If this is not possible, addi-
tional constructional measures to improve sound insulation may
be required. It must be possible to carry out maintenance work
without hindrance. This can be ensured by maintaining a clear-
ance of 1.2 m on all sides of the device.
Do not restrict or block the area around the air intake or outlet.

5.2 Condensed Water Pipe

Condensed water that forms during operation must be drained
off frost-free. The heat pump must be mounted on a level plane
to guarantee proper drainage. The condensed water pipe must
have a minimum diameter of 50 mm and must be fed frost-free
into a sewer. Condensate should not be discharged directly into
clearing tanks and cesspits because the aggressive vapours
could destroy the evaporator.

Set-up

ATTENTION!