DeWalt DC300 Guide D'utilisation page 16

3. Using the retracting lever, retract lower blade guard to an
upward position. Lower rear of shoe until blade teeth almost
touch cutting line.
4. Release the blade guard
FIG. 15
(its contact with the work
will keep it in position to M
open freely as you start
the cut). Remove hand
from guard lever and
firmly grip auxilary handle,
(M) as shown in Figure
15. Position your body
and arm to allow you to
resist kickback if it occurs.
5. Make sure blade is not in contact with cutting surface before
starting saw.
6. Start the motor and gradually lower the saw until its shoe rests
flat on the material to be cut. Advance saw along the cutting line
until cut is completed.
7. Release trigger and allow blade to stop completely before with-
drawing the blade from the material.
8. When starting each new cut, repeat as above.
MAINTENANCE
Cleaning
Use only mild soap and a damp cloth to clean the tool. Many house-
hold cleaners contain chemicals which could seriously damage
plastic. Also, do not use gasoline, turpentine, lacquer or paint thin-
ner, dry cleaning fluids or similar products. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Lubrication
Self lubricating ball and roller bearings are used in the tool and relu-
brication is not required. However, it is recommended that, once a
year, you take or send the tool to a certified service center for a
thorough cleaning, inspection, and lubrication of the gear case.
Repairs
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustments (including brush inspection and
replacement) should be performed by a D
center, a D WALT authorized service center or other qualified
E
service personnel. Always use identical replacement parts.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please
contact D WALT Industrial Tool Co., 701 East Joppa Road,
E
Baltimore, MD 21286, call 1-800-4-D
visit our website www.dewalt.com.
CAUTION: The use of any other accessory not recommended
for use with this tool could be hazardous.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty mate-
E
rials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
15
WALT factory service
E
WALT (1-800-433-9258) or
E
WALT (1-800-
E