Preparation; Things To Be Done For Saving Energy - Grundig GWN21210X Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 179
4

Preparation

4.1 Things to be done
for saving energy
Connecting your refrigerator
A
to systems that save energy
is dangerous as they may
cause damage on the
product.
• Do not leave the doors of your
refrigerator open for a long
time.
• Do not put hot food or drinks
in your refrigerator.
• Do not overload the
refrigerator. Cooling capacity
will fall when the air
circulation in the refrigerator
is hindered.
• Do not place the refrigerator
in places subject to direct
sunlight. Install the product
at least 30 cm away from heat
sources such as hobs, ovens,
heater units and stoves and
at least 5 cm away from
electrical ovens.
• Pay attention to store your
food in refrigerator in closed
containers.
• To be able store maximum
food in the freezer
compartment of your
refrigerator, the upper
drawer has to be removed
and placed on top of glass
shelf. Power consumption
stated for your refrigerator
has been determined after
removing the icematic and
the upper drawers as to
allow maximum loading. It
is strongly recommended to
use the lower drawers in the
freezer and the multizone
compartment while loading.
• Airflow should not be blocked
by placing foods in front of
the freezer and the multizone
compartment fans. Foods
should be loaded by leaving
minimum 5 cm space in front
of the protective fan grid.
• Thawing the frozen foods in
the fridge compartment both
saves energy and reserves
the quality of the foods.
C
Temperature of the room
where your refrigerator
is located should at least
be
10ºC /50°F
your refrigerator under
cooler conditions is not
recommended with regard
to its efficiency.
DA
SV
NO
CZ
SK
PL
NL
. Operating
RO
13

Publicité

Table des Matières
loading

Table des Matières