Auto Power Off - Uline H-5836 Mode D'emploi

AUTO POWER-OFF
When the auto power-off time is enabled, the scale will
automatically turn off when there has been no load on
the platform and the scale is stable at zero position for a
specified period of time (in minutes). At startup, the auto
power-off is disabled. Enter this menu to turn the auto
power-off feature on or off.
1. Press and hold the ZERO key
SET bF
will be shown on the display.
2. Press the TARE key
display.
3. Press the ZERO key
menu.
4. Press the TARE key
shown on the display.
oFF
• – Auto power-off is off.
oF 5
• – Auto power-off at 5 minutes.
oF 15
• – Auto power-off at 15 minutes.
the ZERO key
5. Press
the UNIT key
6. Press
HIGH/LOW LIMIT BEEPING SOUND
At startup, the beeping sounds are set to beep when
weights are inside the limits. Enter this menu to change
the beeping sound setting.
1. Press the UNIT key
the same time until
2. Press the TARE key
display.
3. Press the ZERO key
4. Press the TARE key
on the display.
nonE
• – No beeping sounds.
o
• – Beeping sounds between the limits.
nG
• – Beeping sounds outside of the limits.
5. Press the ZERO key
6. Press the UNIT key
PAGE 10 OF 36
SETUP MENU CONTINUED
for three seconds.
SET oF
until is shown on the
to enter the auto power-off
until the desired setting is
to select the new setting.
to exit the sub menu.
and the PCS/SET key
SEt H
is shown on the display.
bEEP
until is shown on the
to enter the submenu.
until desired setting is shown
to select the new setting.
to exit to the weighing mode.
ENABLE DYNAMIC WEIGHING
At startup, the dynamic weighing mode is enabled. Enter
this menu to turn the dynamic weighing mode on or off.
1. Turn on the scale and press the PCS key during the
Pn
self-test.
2. Press the G/N key
then the TARE key
display.
3. Press the TARE key
display.
4. Press the ZERO key
be shown on the display.
5. Press the ZERO key
6. Press the TARE key
shown on the display.
on
• – Dynamic weighing is on.
oFF
• – Dynamic weighing is off.
7. Press the ZERO key
8. Press the UNIT key
ENABLE ACCUMULATION, AUTO
ACCUMULATION AND RS-232
At startup, the accumulation mode is enabled. Enter this
at
menu to turn the accumulation and auto accumulation
modes on or off and to set the RS-232 communication.
1. Turn on the scale and press the PCS key
the self-test.
2. Press the G/N key
then the TARE key
display.
3. Press the TARE key
display.
4. Press the ZERO key
will be shown on the display.
will be shown on the display.
, then the UNIT key
Po CHF
. will be shown on the
P3 oth
until
to enter the menu.
to enter the sub menu.
until the desired setting is
to select the new setting.
twice to exit the menu.
Pn
will be shown on the display.
, then the UNIT key
Po CHF
. will be shown on the
P1 com
until
to enter the menu.
and
is shown on the
anm
will
during
and
is shown on the
Mode
0621 IH-5836