Turning Scale On/Off - Uline Ohaus Ranger Count 3000 Mode D'emploi

TURNING SCALE ON/OFF

To turn on scale, press and hold the On/Zero Off
button for 1 second. The scale performs a display test,
momentarily displays the software version and then
enters the active weighing mode.
To turn off scale, press and hold the On/Zero Off button
until OFF is displayed.
COUNTING
Ranger Count 3000 has three display areas. Weight,
Piece Weight and Count information are displayed in
these areas, respectively.
PRESET TARE
Enter a value with the numeric keypad. The value will be
displayed in the Count window.
Pressing Tare key, the value in current unit will then be
saved as the preset tare.
To clear the tare value, clear the pan and press Tare key.
APW ESTABLISHMENT
If there is no APW established, both the piece weight
display and the count display will show 0.
PAGE 5 OF 69
OPERATION CONTINUED
Lock Switch
POSITIVE SAMPLING
1.
2. Input the sample size with the numeric keypad. The
3. Press the Sample key. [------] will be displayed in both
4. The established APW and count will be displayed.
NEGATIVE SAMPLING
1.
2. Tare the scale, a NET 0 will be displayed.
3. Remove the samples from the container; weight
4. Input the sample size with the numeric keypad.
Power Input
Place the sample on the pan.
value is displayed in the count window. Alternatively,
the Sample key can be used instead. [------] is
displayed in the count window when sample key is
pressed. Input the sample size value (only integer).
the piece window and the count window.
Place container with the samples on the pan.
window will now display a negative net reading.
The value will be displayed in the count window.
Alternatively, the Sample key can be used instead.
[------] is displayed in the count window when
sample key is pressed. Input the sample size value
(only integer).
Weigh Below
Access
RS232 and Option
Interface Port
(below cover)
1021 IH-9554