Installing Components; Connecting Power; Selecting Location - Uline Ohaus Ranger Count 3000 Mode D'emploi

INSTALLING COMPONENTS

Install the sub-platform and metal pan. Press to lock the
sub-platform into place. (See Figure 1)
NOTE: The scale can be operated without the
pan, if desired.
Figure 1

SELECTING LOCATION

Use the scale on a firm, steady surface. Avoid locations
with excessive air current, vibrations, heat sources or
rapid temperature changes. Allow sufficient space
around the scale.
LEVELING EQUIPMENT
The Ranger Count Series has a level indicator as a
reminder that the scale should be leveled for accurate
weighing. To level the scale, adjust the feet so the
bubble is centered in the circle. Ensure the equipment is
level each time its location changes. (See Figure 2)
Figure 2
PAGE 2 OF 69
INSTALLATION CONTINUED
Level Indicator
Yes No
Adjustable Feet

CONNECTING POWER

AC power is used to power the scale when battery
power is not needed. Connect the AC power cord
(included) to the power input jack. Connect the AC
plug to an electrical outlet. (See Figure 3)
Figure 3
BATTERY POWER
The scale can be used on AC power immediately. Allow
the battery to charge for 12 hours before using the
scale on battery power. The scale will automatically
switch to battery operation if there is a power failure or
the power cord is removed. With AC power, the scale
is constantly charging, so the battery charge indicator
(see symbol on page 4) will remain lit. The scale can
be operated during charging. The battery is protected
against overcharging.
During battery operation, the battery symbol indicates
the battery charge level. The scale will automatically
turn off when the batteries are fully discharged. For
maximum operating time, the battery should be
charged at room temperature.
SYMBOL CHARGE LEVEL
0 to 10% Remaining
11 to 40% Remaining
41 to 70% Remaining
71 to 100% Remaining
1021 IH-9554