AERMEC VMF-E4X Manuel D'installation page 11

To select the configuration suitable for the specific installation, simply perform the three operations shown in the figure below:
Step 1: Press the or button
Step 2: With the buttons
Step 3: Press the button
PANEL DISPLAYS
The E4X panel, as highlighted in the paragraph of the applications, can be used in installations of different complexity and therefore it is necessary to
provide specific displays to identify any anomalies or particular operating conditions of the system.
ADDRESSING OF THE FAN COILS
As seen in the "Centralized system" application, the E4X panel can be connected to a "master" fan coil of a zone. The latter, in order to communicate with
the supervision system, needs to be uniquely addressed during installation. This "addressing" process is carried out by the supervision system (BMS/
VMF) and its execution can be identified by the user through the display in which the flashing of the string "Add" is highlighted:
To associate an address to the thermostat from the supervision system, simply press the key
mation that the outcome of the procedure was successful is given by the change in display of panel E4Xwhich shows the alternation of the Add string
with the decimal value of the address just associated to the thermostat.
The end of the "auto-addressing" procedure is dictated by the supervision system, therefore, when this occurs panel E4X returns to normal operation
displaying the main screen.
OFF
SET
+
AUTO
AUX
MODE
SELECT
OFF OFF
SET SET
+ +
OFF
SET
+
AUTO AUTO
AUTO
OFF
SET
AUX AUX
+
AUX
AUTO
MODE MODE
AUX
SELECT SELECT
MODE
to switch to the air probe management type change
SELECT
mode.
MODE
SELECT
OFF OFF
SET SET
+ +
AUTO AUTO
SET OFF
AUX AUX
+
AUTO
MODE MODE
or change the air probe management mode.
AUX
SELECT SELECT
MODE
or wait 10 seconds to return to the main screen.
SELECT
OFF
SET
+
AUTO
AUX
MODE
SELECT
SET OFF
+
AUTO
AUX
MODE
(make sure the thermostat is ON before hand). Confir-
SELECT
AVMFE4XLJ-0821 - 6795769_03
11