Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Always lock trigger or remove battery pack
before changing or removing accessories. Only
use accessories specifically recommended for
this tool. Others may be hazardous.
Attaching and Removing the Tool Hanger (Fig. 3)
(Cat. No. 9099-20 or as an accessory)
Fig. 3
Gear case
screws
1.
To attach, remove the two top gear case screws (Fig. 3).
2.
Place the ring through the tool hanger.
3.
Position the tool hanger on the tool over the two gear case screw
holes.
4.
Replace the two gear case screws. Hand tighten the screws.
5.
To remove, reverse the procedure.
Attaching and Removing Accessories (Fig. 4) (Cat. No. 9078-20)
This impact wrench is intended only for use with sockets designed for
impact wrenches and that have a 3/4" square drive. Other sockets could
shatter or break, causing injury.
Fig. 4
Drive shank
1.
To attach a socket or other accessory, push the accessory onto
the drive shank until it snaps into place.
2.
To remove the accessory, pull it off the drive shank.
Use
only
sockets
specifically designed for use on impact wrenches
and drivers. Other sockets and accessories
might shatter or break causing injury.
All manuals and user guides at all-guides.com
TOOL ASSEMBLY
WARNING!
Ring
Tool
hanger
WARNING!
and
other
accessories
Attaching and Removing Accessories (Fig. 5) (Cat. No. 9079-20)
This impact wrench is intended only for use with sockets designed for
impact wrenches and that have a 1/2" square drive. Other sockets could
shatter or break, causing injury.
Fig. 5
Drive shank
Detent pin
1.
To attach a socket or other accessory, align the hole in the acces-
sory with the detent pin on the drive shank. Hold the detent pin in
while pushing the socket onto the drive shank. The detent pin will
snap into place in the hole to secure the socket.
2.
To remove the accessory, insert a nail or other thin object into the
hole in the accessory and press the detent pin in. Pull the accessory
off the drive shank.
Attaching and Removing Accessories (Fig. 6)
Cat. No. 9099-20 and other Impact Wrenches using the Quick Change
1/2" Square Drive to 7/16" Hex Adapter
Cat. No. 9099-20 and accessory Cat. No. 48-66-0061 are intended for
use with drill bits and adapters with a 7/16" Hex Quick Change shank,
which has a ball-retainer groove. It is not intended for use with Hex Shank
Bit Extensions.
Fig. 6
Open (Release)
Ball-retainer
groove
Closed (Locked)
1.
To attach an accessory, pull the chuck collar forward and insert the
accessory shank. Release the collar. It may be necessary to pull the
bit out slightly to engage the holding mechanism.
2.
To remove the accessory, pull the chuck collar forward and remove
the accessory. Release the collar.
page 5
Publicité
Table des Matières
