Klarstein METROBREEZE 9 PARIS Mode D'emploi page 33

Clean the fi lter screen
If the fi lter screen is clogged with dust, and the effectiveness of the air
conditioning is reduced, be sure to clean the fi lter screen once every two weeks.
Clean the upper fi lter screen frame
1. Clasp the wedging block of
the EVA fi lter screen frame
with hands. Force down from
the outside to remove the EVA
fi lter screen frame. Unscrew
four screws fi xing the EVA fi lter
screen and the rear housing to
remove the EVA fi lter screen (as
shown in the above fi gure) .
2. Put the EVA fi lter screen into
warm water with neutral
detergent (about 40
) and dry it in the shade after
rinsing clean.
Clean the lower fi lter screen frame
1. Hold the handle of the CON
fi lter screen frame, and pull it
outward gently to remove it.
2. Put the CON fi lter screen into warm water with neutral detergent (about 40
/ 104 ) and dry it in the shade after rinsing clean.
Postseason Storage
1. Unscrew the drainage cover, unplug the water plug, and discharge the
water in the water pan into other water containers or directly tilt the body to
discharge the water into other containers.
2. Turn on the machine, adjust it to low-wind ventilation mode, and maintain this
state until the drainage pipe becomes dry, so as to keep the inside of the body
in a dry state and prevent it from mildewing.
3. Turn off the machine, unplug the power plug, and wrap the power cord
around the wrapping post; install the water plug and the drainage cover.
4. Remove the exhaust pipe and keep it properly.
5. Cover the air conditioning with a plastic bag. Put the air conditioning in a dry
place, keep it out of the reach of children, and take dust control measures.
6. Remove batteries of the remote control and keep them properly.
7. Note: ensure that the body is placed in a dry place and keep all machine
components properly.
/ 104
1 Retaining screw
2 Wedging block
3 Wedging block
1
2
3
EN
33