Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating external components with the remote control
The buttons described below are used on pages 12 and 13.
Number
buttons
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.
Operating the TV
7 To set the manufacturer's code
1
Slide the remote control mode selector
to TV.
2
Press and hold F TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
Manufacturer
JVC
Hitachi
Magnavox
Mitsubishi
Panasonic
Philips
RCA
Remote
* "01" is the initial setting.
control mode
5
selector
Release F TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
(play button)
F TV:
TV VOL +/–:
TV/VIDEO:
CH +/–:
1-10, 0, h10 (100+): Selects the channel.
TV RETURN:
NOTE
• The operating buttons may differ depending on manufacturers.
Operating the DBS tuner or
CATV converter
7 To set the manufacturer's code
1
Slide the remote control mode selector
to VCR/DBS.
2
Press DBS.
3
Press and hold F VCR/DBS.
Keep the button pressed until step 5 is finished.
4
Press ENTER.
Code
Manufacturer
01*
Samsung
10
Sanyo
02
Sharp
03
Sony
04, 11
Toshiba
15
Zenith
05
Turns TV on and off.
Adjusts the volume.
Selects the input mode (either TV or
VIDEO).
Changes the channels.
Alternates between the previously selected
channel and the current channel.
Continued on the next page
Code
12
13, 14
06
07
08
09
12
Publicité
Chapitres
Table des Matières
Dépannage
