If Something Does Not Work - AEG Electrolux S 64190 KA1 Mode D'emploi

GB

If something does not work

During operation of the appliance some smaller but annoy-
ing trouble can often occur, which does not require calling a
technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes with
certain sounds (compressor- and circulating sound). This is not
trouble, but means normal operation.
We draw it to your attention again that the appliance
operates discontinuously, so the stopping of compres-
sor does not mean being no-current. That is why you must
not touch the electrical parts of the appliance before break-
ing the circuit.
Problem
The appliance does not cool Thermostatic control is set too low.
sufficiently
Too many foods to be cooled were put in.
Very warm foods were put in.
Door is not shut properly.
There is no inside cool air circulation.
The appliance cools too The thermostatic control is set too high.
hard
The appliance does not cool Plug is not connected to the mains socket properly.
at all
There is no voltage in the mains socket.
Thermostatic control is in „0" position.
The appliance is noisy The appliance is not supported properly.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
52
All manuals and user guides at all-guides.com
Possible cause Solution
Set higher position.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Provide inside cool air circulation.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the four feet
should be on the floor).