Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb - AEG Electrolux S 64190 KA1 Mode D'emploi

Clean the melting water outlet with the supplied pipe scraper
that can be seen in the figure. The pipe scraper has to be
stored in the outlet.
Occasionally check defrost water outlet not to be clogged up.
The most typical case of clogging up in the defrost water out-
let when you put food wrapped in some paper into the appli-
ance and this paper contacts back plate of fresh food com-
partment and freezes to it. If you remove the food right at
this moment the paper will tear and it can cause clogging up
in the outlet by getting into it. So you are asked to be care-
ful - because of the above - when placing foods wrapped in
paper into the appliance.
In case of increased demand e.g. during heatwaves, the
refrigerator temporarily happens to operate constant-
ly. During this the automatic defrosting is ineffective.
Remaining small ice and frost stains on back plate of the
fresh food compartment after defrosting period is not abnor-
mal.
The frozen food compartment can not be equipped with
automatic defrosting set since the deep-frozen and frozen
foods do not endure melting temperature.
So the enclosed plastic scraper is for scraping off and remov-
ing frost and ice coating which possibly occurs in the frozen
food compartment and on the sealing of the door.
The tray in figure is not a piece of accessories to the appli-
ance!
When ice coating is so thick that it can not be removed with
the plastic scraper, the frozen food compartment has to be
defrosted (generally 2-3 times a year).
Take the foods out of the frozen and fresh food compartment,
wrap them into some layers of paper or cloth. Put them to a
possible cool place while defrosting.
Break the circuit of the appliance and leave the doors of
frozen and fresh food compartment open.
Continuously blot off the defrosting water by a soft cloth or
sponge.
After defrosting wipe the surfaces, apply voltage to the appli-
ance and put the foods back to their places.
It is recommended to operate the appliance at the highest
position of the thermostatic control so that it can reach the
proper storing temperature as soon as possible.
All manuals and user guides at all-guides.com

Regular cleaning

It is recommended to wash the inside of the refrigerator in 3-
4 weeks time.
Household cleaner or soap must not be used.
After you made it no-current wash the appliance using luke-
warm water and wipe it.
Clean the magnet door rubber profile with clean water.
After cleaning plug the appliance to the mains socket.
It is practical to clean and defrost the frozen food compart-
ment at a time and when it is empty.
Dust and dirt collected on the back of the refrigerator, con-
denser is recommended to be removed and clean the evapo-
rative tray on top of the compressor once or twice a year.

When the refrigerator is not in use

In case the appliance will not be used for a long time follow
these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then take the
lamp cover off in the direction of arrow and the bulb can be
changed. (Type of the bulb: Mignon 322, 230 V, 15 W, E 14
thread)
After changing bulb replace the lamp cover, screw the plate
screw and apply voltage to the appliance.
The lack of light does not influence operation of the refrig-
erator.
GB
51