Instructions For The Installer; Transportation, Unpacking; Cleaning; Placement - AEG Electrolux S 64190 KA1 Mode D'emploi

GB

Transportation, unpacking

It is recommended to deliver the appliance in original
packaging, in vertical position considering the pro-
tective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on it.
Report possible damages immediately to the place you
bought it. In that case retain packaging.

Cleaning

Remove every adhesive tape, which ensure the parts not to
move in the appliance.
Wash the inside of the appliance using lukewarm water and
mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.

Placement

The ambient temperature has an effect on the energy con-
sumption and proper operation of the appliance. When plac-
ing, take into consideration that it is practical to operate the
appliance between ambient temperature limits according to
the climate class that is given in the chart below and can be
found in the data label.
Class of climate
SN
N
ST
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond the
prescribed temperature.
If the ambient temperature goes beyond the upper data this
means longer operating time of the compressor, breakdown
in the automatic defrosting increasing temperature in the
cooling compartment or increasing energy consumption.
When placing the appliance ensure that it stands level. This
can be achieved by two adjustable feet (1) at the bottom in
front. 1-1 piece of distance washer (2) are accessories of the
adjustable feet. If levelling the appliance requires, these
washers can be removed.
48
All manuals and user guides at all-guides.com

Instructions for the Installer

Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
45°
PR60
The plastic bag of accessories also contains two spacers to
be fitted into special holes in the back of the appliance. Fit
the spacers into the holes, taking care to ensure that the
arrow (A) is positioned as shown in Figure. Then turn them
through 45° (arrow (A) vertical) until they lock into place.
Do not stand the appliance on a sunny place or close to a
radiator or cooker.
If it is unavoidable because of furnishing and the appliance
has to be stood near a cooker take these minimum distances
into consideration:
In case of gas or electric cooker 3 cm must be left, when
it is less put a 0,5-1 cm non-flam insulation between the
two appliances.
In case of oil or coal-fired stove the distance must be 30
cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal distances
recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
A