Using Range; Hold And Autohold Mode; Capturing Minimum And Maximum Values; Relative Values - koban KMIR-01 Mode D'emploi

KMIR-01

4.12. Using RANGE

Press the RANGE key to activate the manual mode
and to disable the Autorange function. The message
"Manual Range" appears on the upper left part of the
display instead of "Auto Range". In manual mode, press
the RANGE key to change measuring range: the relevant
decimal point will change its position. The RANGE key is
not active in positions % 10A . In Autorange
mode, the instrument selects the most appropriate ratio
for carrying out measurement. If a reading is higher than
the maximum measurable value, the indication "O.L"
appears on the display. Press and hold the RANGE key for
more than 1 second to exit the manual mode and restore
the Autorange mode.

4.13. Hold and AutoHold Mode

To freeze the display for any function, press key HOLD.
And again press key HOLD to release freeze.
20
EN EN

4.14. Capturing Minimum and Maximum Values

The MAX MIN Record mode captures minimum, and
maximum input values. When the input goes below the
recorded minimum value or above the recorded maximum
value, the Meter beeps and records the new value. This
mode is for capturing intermittent readings, recording
minimum and maximum readings unattended, or recording
readings while equipment operation precludes watching
the Meter. To activate the MAX MIN mode, press soft key
labeled . If the Meter is already in MAX MIN function,
press causes the Meter to turn off MAX MIN function.

4.15. Relative Values

To activate the relative mode, press the soft key labeled
. If the Meter is already in the relative function, press
causes the Meter to turn off relative.
4.16. Capturing Peak Values
To activate the peak mode, press the soft key labeled .
If the Meter is already in the peak function,
Meter to turn off peak.
KMIR-01
causes the
21