Environmental Concerns - Electrolux SANTO 75338-2 DT Notice D'utilisation

36

Environmental concerns

8. Install the handle in the opposite side.
Re-screw the handle bracket on the door
(h4). Turn the handle bracket with the
handle and screw them to the door (h5)
and the fitted handle bracket (h6).
9. Install the top door on the pin (G). Insert
the pivot of the middle hinge (H) into the
hole of the top door. Make sure that the
plastic space is placed under the hinge. Install the bottom door on the lower hinge
pivot (f). Slightly tilting the doors insert the pivot of the middle hinge (H) into the hole
of the bottom door.
10. Keeping the doors open, tighten the middle hinge with two screws.
11. Make sure that the front board of the door is parallel to the front board of the top.
12. Reposition, level the appliance, wait for at least four hours and then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the gasket.
Environmental concerns
The symbol
treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this product is disposed
of correctly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailed information about recycling of this product, please contact
your local council, your household waste disposal service or the shop where you purchased
the product.
on the product or on its packaging indicates that this product may not be
h4 h5 h6