Service; Environment Protection; Control Panel; Switching On - Electrolux SANTO 75338-2 DT Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Service

• Any electrical work required to do the servicing of the appliance should be carried out
by a qualified electrician or competent person.
• This product must be serviced by an authorized Service Centre, and only genuine spare
parts must be used.

Environment Protection

This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance shall not be discarded together
with the urban refuse and rubbish. The insulation foam contains flammable gases: the
appliance shall be disposed according to the applicable regulations to obtain from your
local authorities. Avoid damaging the cooling unit, especially at the rear near the heat
exchanger. The materials used on this appliance marked by the symbol

Control panel

1
1
Fan function switch
Fan light
2
Temperature regulator
Frostmatic button
3
Frostmatic indicator

Switching on

Remove, if present, the remove label stuck on the inside of the freezer compartment.
Insert the plug into the wall socket.

Switching off

To switch off the appliance remove the mains plug.

Temperature regulation

The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• press the temperature regulator more times until the LED corresponding to the required
temperature lights up. Selection is progressive, varying from +2°C to +8°C.
A medium setting is generally the most suitable.
2
3
23
Control panel
are recyclable.

Publicité

Table des Matières
loading

Table des Matières