Electrolux SANTO 75338-2 DT Notice D'utilisation page 35

2. Slide the top door off the pin (G). Un-
screw the pin (G) and install it on the
opposite side.
3. Remove the two plugs from the middle
crossbeam and install them on the op-
posite side, covering the holes left free
from the removed hinge.
4. Remove the plugs (1) on the upper side
of both doors and move them to the
other side.
5. Remove with a tool the cover (e), un-
screw the lower hinge pivot (f) using a
10 mm spanner and re-screw it on the
opposite side.
6. Install the cover (e) on the opposite side.
7. Remove the handle. Unscrew the top
handle bracket from the handle rod (h1).
Unscrew the bottom handle bracket
from the door (h2). Unscrew the top
handle bracket from the door (h3).
Install the plug (1).
Installation
1
2
1
4
h1 h2
35
G
e
5
f
3
h3