Panasonic CF-VDM302T Mode D'emploi page 16

Troubleshooting
The computer does not recog-
nize the drive
The Multimedia pocket device
status indicator
Cannot play disc or read data
from it
Cannot eject disc
The disc tray does not close
Other disc operation problems
16
All manuals and user guides at all-guides.com
Check the settings by following the instructions in
"Preparations" (
Is the drive properly mounted in the multimedia
pocket?
Restart the computer.
Is the disc loaded on the tray correctly?
(
does not light
Is the disc bent, scratched, or dirty?
An error may occur if, after the tray has been closed
or operation has been resumed from the sleep
(Windows Vista), standby (Windows XP)/hibernate
modes, the drive is accessed before the Multimedia
Pocket device status indicator
error may occur if the drive is accessed by the ap-
plication software automatically. In a case like this,
remove the disc, re-insert it, and try again.
Turn on the computer.
To remove a disc when the
computer is powered off, insert
a pointed object (e.g., the bent-
out tip of a paper clip)
into the emergency hole (A). Pushing it completely
to the end will free the tray so that it can be pulled
out. (The position of the emergency hole differs
depending on the drive.)
If a disc with fi ngerprints or other dirt is used, you
may not be able to remove it. Use a clean disc.
(
Do not touch the eject button when closing the tray.
Use another drive or media.
page 11).
page 11)
page 10)
goes off. Also, an