Aircare MA1201 Manuel De L'utilisateur page 6

ABOUT THE CODES
F – The F code means your unit is empty and needs to be FILLED with water.
CL – Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for five seconds, until
CL appears. Your Console will lock on the current fan and humidity settings. Release the lock by pressing the power button again for five
seconds until the display flashes CL twice, letting you know the lock is off.
CF – The CF code triggers after 720 hours of use and means it's time to CHECK YOUR FILTER (wick). Unplug your unit and check your
wick. If your wick is still in good shape, simply clear the code by plugging your humidifier back in. If your wick needs replacing, install a new
MAF1 Super Wick®:
5
9
Plug in your unit and press the power
button power-of.
10
Set your desired fan speed by pressing
the fan button
three fan speeds that are displayed by F1 (the
lowest speed) through F4 (the highest speed).
The additional AUTO setting (displayed by an A)
allows the fan speed to adjust automatically to
your humidity setting.
Note: On higher speeds, the Console puts out a tremendous
amount of humidity, so it's louder on these levels. Most of our
customers liken it to the sound of a box fan. Rest assured there is
nothing wrong with your unit, it's just working very hard to put out
much-needed humidity.
11
Press the humidity control button
set your humidity level from 25% to 65%.
The humidistat on your cord will read your home's
humidity and turn your fan off when the set level
is reached. When set to 65%, your unit will run
continuously.
That's it! Your Console is ready to use.
. Your Console has
to