Dimplex SIK 7 TE-2 Instructions D'installation Et D'utilisation page 25

6 Complies with the European safety regulations
7 Additional model features
7.1 Water in device is protected against freezing
7.2 Max. operating overpressure (heat source/heat sink)
1. These data indicate the size and capacity of the system. For an analysis of the economic and energy efficiency of the system, both the bivalence point and the regulation should
be taken into consideration. These specifications can only be achieved with clean heat exchangers. Information on the maintenance, start-up and operation can be found in the
respective sections of the installation and operating instructions. The specified values, e.g. B10 / W55, have the following meaning: Heat source temperature 10 °C and heating
water flow temperature 55 °C.
2. The specified sound pressure level corresponds to the operating noise of the heat pump in heating operation with a flow temperature of 35°C. The specified sound pressure level
represents the free sound area level. The measured value can deviate by up to 16 dB(A), depending on the installation location.
3. Factory settings
4. Note that additional space is required for pipe connections, operation and maintenance.
5. See CE declaration of conformity
6. The heat circulating pump and the heat pump controller must always be ready for operation.
www.dimplex.de
All manuals and user guides at all-guides.com
6
5 5
yes yes
bar 3,0 3,0
12
5 5
yes yes
3,0 3,0
E-11