Honeywell HW400PI Guide D'utilisation page 17

All manuals and user guides at all-guides.com
Electrical overload
Low voltage input
LED is red
Overheating
LED is green
but no power Damaged power inverter
output
Audio system internal
Audio system
power supply not filtering
interference
modified sine wave
HW400PI Power Inverter Owner's Manual
Troubleshooting
Disconnect appliance(s), disconnect
power inverter, wait a few minutes,
plug in the power inverter, and plug in
reduced load. Charge appliances with
power ratings less than 400 watts
AND with surge power less than 600
watts.
Low voltage shutdown has occurred;
Start vehicle to recharge battery or
check vehicle battery voltage.
Thermal shut-down protection has
occurred; Unplug accessories and
leave the power inverter plugged in
allowing fan to cool the unit. Clear
objects away from power inverter to
improve air flow, move it to a cooler
location, or reduce load if power
inverter is operated continuously.
Never use a damaged power inverter.
See "Warranty", page 16.
Use audio system with higher quality
filtering.
www.honeywellpowerinverters.com 14