Additional Information; Setting The Sleep Timer; Dimming The Display; Dts Cd Setting - Pioneer HTS-560DV Mode D'emploi

10

Additional information

Chapter 10
Additional information
Important
• Many of the buttons used extensively in this chapter
are used in conjuction with the SHIFT button.
The cursor buttons (
should all be used with SHIFT in the following
explanations.

Setting the sleep timer

The sleep timer switches off the receiver subwoofer after
a specified time so you can fall asleep without worrying
1
about it.
1 Press the SLEEP button to select an option.
Choose between the following options:
• SLP ON – Switches off after about an hour
• SLP OFF – Cancels the sleep timer
After selecting SLP ON, you can press SLEEP again to
check how much time is left. Each line indicates
approximately 12 minutes (remaining):
S L P - - - - -

Dimming the display

ENTER
TOP MENU
SOUND
ST
TEST
TONE
/
Note
1 The display dims when the sleep timer is set. The DVD player does not automatically switch off with the sleep timer.
2 The display dims when the sleep timer is set, regardless of this setting.
32
En
), ENTER and SETUP
SOUND
AUDIO SUBTITLE ANGLE RETRIEVER
PLAY MODE ZOOM DISPLAY SLEEP
TV
INPUT
CHANNEL VOLUME
SHIFT TV CONTROL
SURROUND
SOUND
AUDIO SUBTITLE ANGLE RETRIEVER
ADVANCED
CLEAR
PLAY MODE ZOOM DISPLAY SLEEP
TUNE MENU
TV
INPUT
SETUP
CHANNEL VOLUME
ENTER
ST
RETURN SHIFT TV CONTROL
MCACC
TUNE
/
You can choose to dim the display if you find it too
2
bright.
1 Press SHIFT+ SETUP .
2 Use the SHIFT+ (cursor left/right) buttons to
select DIMMER then press SHIFT+ ENTER .
3 Use the SHIFT+ (cursor up/down) buttons to
select LIGHT or DARK then press SHIFT+ ENTER .

DTS CD setting

If you play a DTS-encoded CD, you will need to change
this setting to hear the decoded signal.
1 Switch the system into standby.
2 Press SHIFT+ SETUP .
3 Use the SHIFT+ (cursor left/right) buttons to
select CD TYPE from the menu, then press
SHIFT+ ENTER .
4 Use the SHIFT+ (cursor up/down) buttons to
select a setting, then press SHIFT+ ENTER .
Select from:
• NORMAL – Use for playback of regular audio CDs.
Some DTS-encoded CDs will output noise when
played.
• DTS-CD – Use for playback of DTS-encoded CDs, but
note that the beginning of regular CD tracks may be
skipped.

Resetting the system

Use this procedure to reset all system settings to the
factory default.
1 Switch the system on.
2 Press and hold SURROUND then press the
STANDBY/ON button on the display unit.
The next time you switch on, all the system settings
should be reset.