Pioneer HTS-560DV Mode D'emploi page 21

Getting started
3 If the receiver subwoofer is off, press
RECEIVER to turn the power on.
4 Press SHIFT+ MCACC .
Try to be as quiet as possible after pressing
SHIFT+ MCACC. The volume increases automatically and
the system outputs a series of test tones.
• To cancel Auto MCACC setup before it has finished,
press SHIFT+ MCACC. The unit will continue to use
the previous settings.
• If the ambient noise level is too high, NOISY blinks in
the display for five seconds. To exit and check the
1
noise levels , press SHIFT+ MCACC, or to try again,
press SHIFT+ ENTER when RETRY shows in the
display.
• If you see an ERR MIC or ERR SP message in the
display, there may be a problem with your mic or the
speaker connections. To try again, press
SHIFT+ ENTER when you see RETRY
When the MCACC setup is complete, the volume level
returns to normal, COMPLETE
Acoustic Calibration EQ is activated.
Note
1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the speakers from
the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that may be affecting the environ-
ment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto MCACC setup.
2 If this doesn't work, press SHIFT+ MCACC, turn off the power, and check the problem indicated by the ERR message, then try the Auto MCACC setup
again.
3 If COMPLETE doesn't appear, it is likely an error occurred during the setup. Please check all connections and try again.
4 See Listening with Acoustic Calibration EQ on page 23 to switch on/off Acoustic Calibration EQ.
2
3
shows in the display, and
4
05
21
En