Additional Information; Setting The Sleep Timer; Dimming The Display; Dts Cd Setting - Pioneer HTS-260 Mode D'emploi

09

Additional information

Chapter 9
Additional information

Setting the sleep timer

The sleep timer switches off the receiver subwoofer after
a specified time so you can fall asleep without worrying
1
about it.
1 Press the SLEEP button to select an option.
Choose between the following options:
• SLP ON – Switches off after about an hour
• SLP OFF – Cancels the sleep timer
After selecting SLP ON, you can press SLEEP again to
check how much time is left. Each line indicates
approximately 12 minutes (remaining):
S L P - - - - -

Dimming the display

You can choose to dim the display if you find it too
2
bright.
1 Press SETUP .
2 Use the
DIMMER then press ENTER .
3 Use the
LIGHT or DARK then press ENTER .
Note
1 The display dims when the sleep timer is set.
2 The display dims when the sleep timer is set, regardless of this setting.
30
En
DVD DTV PC/GAME AUX
TUNER
SLEEP
ENTER CLEAR
SR
SETUP
TUNE
ST
ST
ENTER
SLEEP
ENTER CLEAR
SR
SETUP
TUNE
ST
ST
ENTER
TEST
SOUND
TONE
TUNE
SOUND
RETRIEVER
SURROUND ADVANCED MCACC
(cursor left/right) buttons to select
(cursor up/down) buttons to select

DTS CD setting

If you play a DTS-encoded CD, you will need to change
this setting to hear the decoded signal.
1 Switch the system into standby.
2 Press SETUP .
3 Use the (cursor left/right) buttons to select
CD TYPE from the menu, then press ENTER .
4 Use the (cursor up/down) buttons to select a
setting, then press ENTER .
Select from:
• NORMAL – Use for playback of regular audio CDs.
Some DTS-encoded CDs will output noise when
played.
• DTS-CD – Use for playback of DTS-encoded CDs, but
note that the beginning of regular CD tracks may be
skipped.

Resetting the system

Use this procedure to reset all system settings to the
factory default.
1 Switch the system on.
2 Press and hold SURROUND then press the
STANDBY/ON button on the display unit.
The next time you switch on, all the system settings
should be reset.