Using This Unit With A Pioneer Plasma Display; Sr+ Setup For Pioneer Plasma Displays - Pioneer HTS-260 Mode D'emploi

08 Other connections
For an external FM antenna, Use a PAL connector to hook
up an external FM antenna.
Using this unit with a Pioneer plasma
display
If you have a Pioneer plasma display
2
SR+ cable to connect it to this unit and take advantage
of various convenient features, such as controlling this
unit via the plasma display's remote sensor, automatic
video input switching of the plasma display, display unit
messages appearing on the plasma display screen, and
automatic volume muting on the plasma display.
Media receiver
CONTROL
SYSTEM CONNECTOR
OUT
USE ONLY WITH DISPLAY UNIT.
SEE INSTRUCTION MANUAL.
AC IN
Important
• With an SR+ cable connected, the remote must now
be pointed towards your plasma display rather than
the display unit of the receiver subwoofer in order to
control the receiver subwoofer.
Note
1 This system is compatible with all Pioneer plasma displays from 2003 onward.
2 The 3-ringed SR+ cable from Pioneer is commercially available under the part number ADE7095. Contact the Pioneer Customer Support division for
more information on obtaining an SR+ cable.
3 You won't be able to use the remote sensor of this unit with the CONTROL IN jack of this unit connected to the CONTROL OUT jack of your plasma
display. You can use the remote sensor of the plasma display (even in standby) as long as the power isn't switched off.
28
En
PAL connector
1
, you can use an
CONTROL
OUT
Pioneer plasma display
ANTENNA
CONTROL IN
MCACC
SETUP MIC
FM AM
UNBAL 75Ω LOOP ANTENNA
AUDIO INPUT
DIGITAL ANALOG
SPEAKERS
DVD DTV PC/GAME AUX
SUB WOOFER R SURROUND L
(COAXIAL) (OPTICAL) (OPTICAL)
L
R
CENTER R FRONT L
• Use a 3-ringed miniplug SR+ cable to connect the
CONTROL IN jack of this unit (through a media
receiver, if applicable) to the CONTROL OUT jack of
3
your plasma display.
Before you can use the extra SR+ features, you need to
make a few settings in the unit—see SR+ Setup for
Pioneer plasma displays below.

SR+ Setup for Pioneer plasma displays

Make the following settings if you have connected a
Pioneer plasma display to this unit using an SR+ cable.
ENTER
SETUP SETUP
ST
SOUND
SOUND
RETRIEVER
SURROUND ADVANCED
CHANNEL
1 Press SR+.
2 Use the (cursor left/right) buttons to
choose SETUP, then press ENTER.
3 Use the (cursor left/right) buttons to
choose the setting you want to adjust.
The current setting is shown for each option as you cycle
through the display. See below for a full list and
description of each.
4 Use the (cursor up/down) buttons to adjust
the setting.
5 Repeat steps 3 and 4 to make other settings.
6 When you're done, press ENTER to leave the SR+
setup menu.
Automatic plasma display volume muting
When Volume Control is switched on, the volume of the
plasma display is automatically muted when the receiver
subwoofer is switched on, or the receiver subwoofer's
input function is changed to one that you would want to
hear the sound from the receiver subwoofer rather than
the plasma display (DVD, for example).
TUNER
SLEEP
CLEAR
SR
TUNE
ST
ENTER
TEST
TONE
TUNE
MCACC
VOLUME