Additional Information; Optional System Settings - Pioneer DCS-575 Mode D'emploi

Additional information

Chapter 11
Additional information

Optional system settings

All the available settings in the standby setup
menu are listed below. See the notes in each
section for more information about the
settings. The first setting in each section is the
default.
1 Switch the system into standby.
Press SHIFT+SETUP and use / then
2
ENTER to choose the setting you want to
adjust.
The available settings are shown in the front
1
panel display.
Use / to adjust then press ENTER to
3
confirm and exit.
System demo setting
Switches the automatic demo feature on or off
(this starts when you plug in for the first time):
• DEMO ON – Switches the demo feature on.
• DEMO OFF – Switches the demo feature off.
TV system setting
The default setting of this system is AUTO, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to AUTO. If you find picture distortion with
some discs, set the TV system to match your
country or region's system. However, this may
restrict the kinds of disc you can watch. See
the table for the kinds of discs compatible with
each setting (AUTO, PAL and NTSC).
Note
1 The setup menu is exited automatically after 5 minutes of inactivity.
2 Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without
color. If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV
has a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands
at the top and bottom of the screen.
3 You have to switch the player into standby (press  STANDBY/ON) before each change.
After using / to choose TV SYS (step
•
2 above), press ENTER to change the TV
system as follows:
• AUTO  NTSC
• NTSC  PAL
• PAL  AUTO
The system automatically switches on and
you'll see the new TV system setting in the
display after seeing WELCOME.
Media Type
DVD/Super VCD/
Video CD/DivX
Video/WMV
CD/MP3/WMV/
MPEG-4 AAC/
JPEG/no disc
DTS CD setting
If you play a DTS-encoded CD, you will need to
change this setting to hear the decoded signal.
• NORMAL – Regular CD playback; some
DTS-encoded CDs output a noisy signal.
• DTS-CD – Proper decoding of DTS-
encoded CDs; the beginning of regular CD
tracks may be skipped.
Key lock setting
• LOCK ON – Makes the front panel buttons
and controls inoperative.
• LOCK OFF – Restores regular use of the
2
front panel buttons and controls.
3
Player setting
Format NTSC PAL AUTO
NTSC
NTSC PAL NTSC
PAL NTSC PAL PAL
— NTSC PAL NTSC or
PAL
11
39
En