Help In Case Of Malfunction - AL-KO KHS 3704 Mode D'emploi

GB

9 HELP IN CASE OF MALFUNCTION

In the event of malfunctions, switch off the log splitter and remove the mains plug. Faults that cannot be
remedied following the table below must be remedied by an authorised specialist company.
Malfunction
Log pusher does not extend/
retract
Log pusher has no force
Hydraulic pump whistles, log
pusher moves jerkily
Motor becomes very hot
Motor does not start
42
Cause
Insufficient hydraulic oil
Hydraulic pump defective
Appliance is tilted towards the
splitting wedge
Insufficient hydraulic oil
Appliance is tilted towards the
splitting wedge
Insufficient hydraulic oil
Appliance is tilted towards the
splitting wedge
Air in circuit
Cable cross-section of an
extension lead too small
Motor protection switch has
switched off
Mains plug or plug socket
defective
Mains cable defective
Electric motor defective
Help in case of malfunction
Remedy
Top up hydraulic oil
Have hydraulic pump replaced
by a specialist company or by
an AL-KO service centre
Position the appliance level or
tilted towards the control lever
Top up hydraulic oil
Position the appliance level or
tilted towards the control lever
Top up hydraulic oil
Position the appliance level or
tilted towards the control lever
Loosen vent plug
Use an extension lead with a
larger cable cross-section
Wait until the motor has cooled
down
Have inspected and replaced, if
necessary, by a qualified
electrician
Have inspected and replaced, if
necessary, by a qualified
electrician
Have inspected and replaced, if
necessary, by a qualified
electrician
KHS 3704 | KHS 5204 | KHS 8552