Operation - Milwaukee M4910-10 Mode D'emploi

INSTALLING REVERSIBLE SPRAY TIP AND
NoZZle tIP GUARD oN PIStol-GRIP
SPRAYER
See Figure 3.
See operator's instructions for flushing, priming, and cleaning
before installing a spray tip. Note all warnings regarding use
of pistol-grip sprayer and the possibility of injection.
 Pull the lock-off lever up to lock the sprayer trigger.
 Install nozzle seat and cap into nozzle tip guard.
 Thread nozzle tip guard assembly onto sprayer and
tighten securely.
 Select spray tip and push securely into nozzle tip guard.
 Keep pistol-grip sprayer trigger locked when not in use.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury .
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ACCESSORIES
All accessories used with this product must be rated a
minimum of 3,200 psi. Ensure compatibility and fit before
using any accessory with this product.
WARNING:
Risk of fire or explosion − spray area must be well
ventilated and away from spark of flames. Failure to heed
this warning could result in serious personal injury.
ASSEMBLY
INSTALLING INTAKE AND RETURN TUBES
See Figure 4.
 Insert the threaded end of the intake tube into the intake
tube connector on the back of the paint sprayer.
 Rotate the connector on the paint sprayer by hand until
the intake tube is attached securely.
 Slide the return tube over the fitting on the paint sprayer
until the tube is fully seated.
 Squeeze the tabs on the spring hose clamp and slide the
clamp over the tube and fitting. Release tabs to secure.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Exterior painting and staining of decks, outdoor furniture,
fences, siding, and interior/exterior spray-painting of
walls, cabinets, and doors.
WARNING:
To reduce the risk of injection NEVER change spray tip
without setting the lock-off on the pistol-grip sprayer and
NEVER point sprayer at any part of the body, persons, or
unit itself. In case of skin injection, seek medical attention
immediately. Failure to heed this warning could cause
serious personal injury.
LOCKING THE PISTOL-GRIP SPRAYER
See Figure 5.
Always lock the sprayer trigger when you have stopped
spraying to prevent the sprayer from being bumped or
triggered accidentally and causing injection.
 Pull the lock-off lever up to lock the sprayer trigger.
 Push the lock-off lever down to unlock the trigger.
RELEASE PRESSURE PROCEDURE
See Figure 5 - 6.
Always follow this procedure when shutting the paint sprayer
OFF for any reason. This procedure releases pressure in the
high pressure hose.
 Lock the sprayer trigger.
 Turn on/off switch OFF.
 Turn prime/spray lever to PRIME. This releases pump
pressure.
9 — English