Replacing The Lamp; Troubleshooting - Electrolux EJ2300AOX Notice D'utilisation

22 www.electrolux.com

6.5 Replacing the lamp

7. TROUBLESHOOTING

WARNING!
Disconnect the mains plug from
the mains socket before you do
the check.
For problems that are not in the
table, contact the Service.
Problem
The appliance makes noise
during operation.
The appliance does not
operate.
The lamp does not come
on.
The compressor operates
continuously.
All manuals and user guides at all-guides.com
Possible solution
Some sounds are normal when the appliance is op-
erating. Refer to the leaflet supplied with the appli-
ance.
Make sure that the appliance is activated.
Make sure that the mains plug is connected to the
mains socket.
Do a check and see if there is voltage. Connect a
different appliance to the same mains socket. To re-
pair a mains socket, contact a qualified electrician.
Close and open the door to make sure that the lamp
is not in standby.
The lamp is defective. Replace the lamp.
Set the temperature knob at a lower position.
Make sure that the appliance door is closed.
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3.
Remove the lamp cover
4. Replace the old lamp with a new one.
Use only lamps for household appli-
ances. The lamp cover shows the
maximum power of the lamp.
5.
Install again the lamp cover.
6. Connect the mains plug to the mains
socket.
The type of light bulb or halogen
lamp used for this appliance, is
only for household appliances. Do
not use it for house lightning.