Replacing The Lamp - Electrolux TC152 Notice D'utilisation

Masquer les pouces Voir aussi pour TC152:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

7.2 Replacing the lamp

The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
Possible cause
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
the door immediately after
closing.
1. Using a screwdriver, remove the
2. Detach the lamp cover in the
3. Replace the lamp with the one that
4. Reassemble the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
7. Open the door.
Solution
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Make sure that there is
cold air circulation in the
appliance.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
screw from the lamp cover.
direction of the arrows.
has identical characteristics and is
specifically designed for household
appliances.
socket.
Make sure that the light switches on.
ENGLISH
53

Publicité

Table des Matières
loading

Table des Matières