Sage the Combi Wave 3 in 1 Guide Rapide page 5

in the oven cavity. Operating
the microwave oven when
empty could cause damage to
the appliance. The microwave
oven can only be operated
when empty if in preheat mode,
the LCD screen will display
when the microwave oven is
preheating. Do not leave the
microwave oven unattended
when in use.
• Do not touch hot surfaces.
Allow the microwave oven to
cool entirely before moving or
cleaning any parts.
• Always press the STOP/
CLEAR button and return
to the default screen prior to
unplugging the unit from the
wall outlet before:
−The appliance is to be
left unattended.
−If not in use.
−Before moving or assembly.
−When storing the appliance.
−Cleaning (see page 33).
• Keep the appliance clean.
Follow the cleaning
instructions provided
in this book.
• Do not operate this appliance
when it has a damaged cord
or plug, when it is not working
properly, or when it has been
damaged or dropped.
• When cleaning surfaces of
door and oven that come
together on closing the door,
use only mild, non-abrasive
soaps, or detergents applied
with a sponge or soft cloth.
The use of corrosive chemicals
in cleaning will damage the
appliance and may result in
radiation leaks.
• The appliance shall not be
cleaned with a steam cleaner.
• Do not place the microwave
oven near the edge of a bench
or table during operation.
Ensure all surfaces are level,
clean and free of water or any
other substances.
• Do not place the microwave
oven on or near a hot gas or
electric burner, or where it could
touch a heated oven.
• When using the microwave
oven, provide adequate air
space above and on all sides
for air circulation (see page 14,
Installation point 2).
• Microwave oven is to be used as
free-standing unit. Do not build
in or enclose microwave oven in
a cabinet or confined space as it
will cause overheating. (Refer to
Installation section on page 14).
• Do not use the microwave oven
on a metal surface, for example
a sink drain board.
• The microwave oven is not
intended to be operated by
means of external timer or
separate remote-control system.
EN
5