Ego Power+ ST1500 Guide D'utilisation page 21

ADJUSTING CUTTING
LINE LENGTH
The trimmer head allows the operator to
release more cutting line without stopping
the motor. As line becomes frayed or worn,
additional line can be released by lightly
tapping the bump knob on the ground
while operating the trimmer (Fig. 14).
WARNING:
the line cutting blade assembly. Excessive line length will cause the motor to overheat
and may result in serious personal injury.
For best results, tap the bump knob on bare ground or hard soil. If line release is
attempted in tall grass, the motor may overheat. Always keep the trimming line fully
extended. Line release becomes more difficult as the cutting line becomes shorter.
LINE REPLACEMENT
NOTICE: Always use standard nylon cutting line with a diameter that does not exceed
0.095 in. (2.4 mm). Using line other than that specified may cause the string trimmer to
overheat or become damaged.
WARNING:
off and become dangerous projectiles.
There are two methods to replace the cutting line:
1. Wind the spool with new line.
2. Install a pre-wound spool.
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
Do not remove or alter
Never use metal-reinforced line, wire, or rope, etc. These can break
14
Bump Knob
21