Ego Power+ ST1500 Guide D'utilisation page 12

MOUNTING AND ADJUSTING THE FRONT-ASSIST HANDLE
WARNING:
assembling parts, making adjustments, cleaning, or when the product is not in use.
1. Remove the battery pack from the trimmer.
2. Loosen the four screws in the
handle with a Phillips screwdriver
(available separately) and remove
the screws and the lower clamp
from the handle (Fig. 6).
3. Attach the front-assist handle and
the lower clamp on the shaft and
secure them by pre-tightening the
four screws. Turn the front-assist
handle upwards so that it points
toward the top of the handle (Fig. 7).
4. ST1500-S: Adjust the front-assist
handle position so that it is between
the rear handle housing and the
joint of the shaft, as shown in Fig.
7. For ST1500: adjust the handle
position so that it is between
the rear handle housing and the
warning label on the shaft. Shorter
users may adjust the handle to a
lower position (away from you) and taller users may adjust the handle to an upper
position (towards you). The handle should be adjusted so that your front arm will
be straight when using the trimmer.
5. Tighten the four screws so that the handle cannot be rotated on the shaft.
12
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
Always remove the battery pack from the product when you are
6
Lower Clamp
7
Front-Assist Handle