Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Disassembly/Reassembly (to reassemble, follow procedures in reverse)
Part & No.
JH3S-B
Drain Plug 25
Cover Bolt 18
Cover Nut 19
Cover 2
Connector 20
Gasket 21
Snap Ring 11
Bimetal Unit
13, 14, 16
Air Vent Case 17
Float Cover 9 &
Screen 10
Float 3
Orifice Plug Gasket 7
Orifice 4
Orifice Gasket 5
* Option
Bimetal Unit 13, 14, 16
Air Vent Valve Seat 15
JH3S-B
JH5SL-B
JH5SH-B
*
*
*
*
Figure A
Snap Ring 11
Air Vent Screen 12
Air Vent Case 17
JH5SL-B/JH5SH-B
Disassembly
Use a wrench to remove
Use a wrench to remove
Remove
Remove gasket and clean
sealing surfaces
Remove the connector
Remove gasket and clean
sealing surfaces
Use appropriate pliers
Remove being careful not
to misshape
Remove bimetal unit
from cover
Use a wrench to remove
Remove from cover
Lift straight up
Remove, careful not to
scratch grounded surface
Use a wrench to remove
Remove gasket and clean
sealing surfaces
Use a wrench to remove
Remove gasket and clean
sealing surfaces
̶ 10 ̶
Reassembly
Coat threads with anti-seize and
tighten to the proper torque
Replace with a new gasket, coat
surfaces with anti-seize
Coat threads with anti-seize and
tighten to the proper torque
Align cover with the connector or the
arrow on the body and attach
Replace with a new gasket,
do not apply anti-seize
Insert the connector
Replace with a new gasket,
do not apply anti-seize
Insert securely into groove
Replace being careful not to
misshape
Reinsert in the proper orientation
(see figure A)
Tighten to the proper torque
Place in cover
Align arrows and insert, insert tab on
bottom into guide on body and push
in until top is flush (see figure B)
Insert into body, being careful not to
scratch its grounded surface
Coat threads with anti-seize and
tighten to the proper torque
Replace with a new gasket, coat
surfaces with anti-seize
Coat threads with anti-seize and
tighten to the proper torque
Replace with a new gasket, coat
surfaces with anti-seize
Figure B
Tab
Arrow
Publicité
Table des Matières
