VALBERG DHP 8 A++ W205T Consignes D'utilisation page 19

B
Changing the program after it is started
You can change the program you selected to dry your laundry with a different program after the drying
machine starts running.
• For instance, select Extra Dry program by turning the On/Off/Program selection knob to select Extra
Dry instead of Iron Dry.
• Press the Start/Stand-by button to start the program.
Adding and removing clothes during stand-by
If you want to add or remove clothes to/from the drying machine after the drying program starts:
• Press the Start/Stand-by button to put the drying machine in Stand-by state. The drying operation
stops.
• Open the loading door while in Standby state, and close the door after you remove or add laundry.
• Press the Start/Stand-by button to start the program.
NOTE:
• Adding laundry after the drying operation starts may cause the dried laundry inside the
machine to mix with wet laundry and leave the laundry damp at the end of operation.
• Adding or removing laundry during drying may be repeated as many times as you wish.
But this operation continuously interrupts the drying operation, and thus increases program
duration and energy consumption. So, it is recommended to add laundry before the program
starts.
• If a new program is selected by turning the program selection knob while the drying
machine is in stand-by, the running program terminates.
WARNING!
• Do not touch the inner surface of the drum while adding or removing clothes during a
continuing program. The drum surface is hot.
Cancelling the program
If you want to cancel the program and terminate the drying operation for any reason after the drying
machine starts running, turn the On/Off/Cancel knob, the program will be cancelled.
Using the appliance
EN