VALBERG DHP 8 A++ W205T Consignes D'utilisation page 17

B
Auxiliary functions
Buzzer / time
Drying machine makes an audible warning when the program is completed. If you don't want
the machine to make an audible warning, press the "Buzzer / Time" button. When you press the
Buzzer/Time button, a light will illuminate and no audible warning will be made when the program
ends.
NOTE:
You can select this function before or after the program starts.
Buzzer/Time button is used to adjust program duration while the Rack/Time programs are selected.
Drying Level
Drying Level button is used for adjusting to desired dryness level. Program duration may change
depending on the selection.
NOTE:
You can activate this function only prior to start of program.
End time
You can delay the end time of the program up to 24 hours with End time function.
1. Open the loading door and place the laundry.
2. Select the drying program.
3. Press the End Time selection button and set the delay time you wish. End Time LED will illuminate.
(When pressed and hold the button, End Time proceeds nonstop).
4. Press the Start / Stand-by button. End Time countdown starts. ":" Separator in the middle of displayed
delay time flashes.
NOTE:
You can add or remove laundry within end time. Displayed time is the sum of
normal drying time and end time. End Time LED will turn off at the end of countdown, drying
starts and drying LED will illuminate.
Changing the end time
If you want to change the duration during the countdown:
Cancel the program by turning the On/Off/Program selection knob. Select the program you want and
repeat the End Time selection process.
Cancelling the end time function.
If you want to cancel the end time countdown and start the program immediately:
Using the appliance
EN