VALBERG DHP 8 A++ W205T Consignes D'utilisation page 18

B
Cancel the program by turning the On/Off/Program selection knob. Select the program you want and
press the Start/Stand-by button.
Warning indicators
NOTE:
Warning indicators may vary depending on the model of your dryer
Filter cleaning
When the program is completed, the warning indicator for filter cleaning turns on.
Water tank
When the program is completed, the warning indicator to empty the water tank turns on. If the water
tank fills up while the program continues, the warning indicator starts flashing and the machine goes
into stand-by. In this case, empty the water tank and start the program by pressing the Start / Stand-by
button. Warning indicator turns off and program resumes.
Filter drawer /Heat exchanger cleaning
When the programme is finished, the cleaning symbol of the heat exchanger or filter drawer may light
up.
Starting the program
Press the Start/Stand-by button to start the program.
Start/Stand-by and Drying indicators will
illuminate to indicate that program started.
Child Lock
The drying machine has a child lock which prevents the program flow from being interrupted when the
buttons are pressed during a program. When the child lock is activated, all buttons on the panel except
the On/Off/Program selection knob are deactivated.
Press the Drying Level and Buzzer buttons simultaneously for 3 buttons to activate the child lock.
The child lock has to be deactivated to be able to start a new program after the current program is
finished or to be able to interfere with the program. To deactivate the child lock, keep the same buttons
pressed for 3 seconds.
NOTE:
• When the child lock is activated, the child lock warning indicator on the screen turns on.
• Child lock deactivates when the drying machine is turned off and on by the On/Off/Cancel
knob.
• When the drying machine runs and the child lock is active, it beeps twice when the
program selection knob is turned. If the child lock is deactivated without returning the
program selection knob to its previous position, program will terminate due to the change in
the program selection knob position.
Using the appliance
EN