Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY OF THE STOP SWITCH
• The long stop switch and throttle wire to the right handle to avoid loss.
ADJUSTMENT OF THE DEPTH
• There are three grooves in the connect plate, the wheels put in the highest
groove when working. When not working, the wheels need putting in the
middle or the bottom grooves(depend on operator's height). Adjust depth skid,
there are several holes in the depth skid, you can adjust it according to self
request.
FUEL
• Clean the filler cap and area around it to ensure that no dirt falls into the tank.
• Make sure that tank fuel is facing up during refueling.
• Do not spile gasoline and do not refueling to the top of tank.
• Engine is ranning on a mixture of a gasoline and two - stroke engine oil.
• Avoid direct contact with a skin,avoid inhaling fuel vapor.
• Bad mixture may cause damage on a device.
• The mixture is in ratio 40:1 (40L fuel and 1L oil ).
• When mixing pour oil into a container first, than add fuel.
• Keep mixture in a dry place,do not expose to sun,do not storage longer than
one month.
• Close the container and shake it by hand to make sure that oil and fuel are
properly mixed.

STARTING THE ENGINE

• Press fuel pump bulb which is located on the underside of the engine at least
five times until is filled with fuel.
Choke lever switch to the "ON".
Pull the starter grip slowly with your right hand until you feel it engage and
then give it a brisk strong pull.
• Pull the starter grip maximally five times in this positon,than chocke lever
switch to the „OFF".
• Continue cranking until engine runs.
• To stop the engine push the slide control on stop symbol" STOP "
BEFORE WORK
• Even if you have operated other tillers, take time to become familiar with the
operation of the tiller`s controls and handling.
• The rotating tines can cause injury. Keep away from the tine shield whenever
the engine is running. If youneed to adjust the tines, or work around the tines
for any reason, always stop the engine. Disconnect the spark plug cap if you
need to clean or handle the tines.
• The tiller tines can throw rocks and other objects with enough force to cause
injury. Before tilling, carefully inspect the area and remove all large debris.

Publicité

Table des Matières
loading

Table des Matières