Installing A Bottom Mounted Unit (Hcssb And Hcssbf Models) - Hatco HCSBF Série Manuel D'installation Et D'instructions

English
Installing a Bottom Mounted Unit
(HCSSB and HCSSBF Series)
NOTICE
Use caution and avoid hitting condensing unit hoses/lines
when installing unit. Damage caused during installation is
not covered under warranty.
NOTE: Accessory Installation Kits that include a self-adhesive
gasket for caulk backing as well as colored silicone
sealant are available. Refer to the OPTIONS aND
aCCESSORIES section.
1. Remove the mounting
bracket assembly from
each corner of the hot/cold
shelf. To remove:
a. Remove the
shipping screws and
washers that attach
each mounting bracket
assembly to the bottom
of the unit.
b. Carefully lift the hot/cold
shelf above the wooden shipping frame, and rotate it far
enough to allow the unit to be set back down on top of
the frame (the mounting brackets will stay on the frame
or fall out the bottom). make sure the flexible tubes from
the condensing unit are not strained or damaged. This
step requires two or more people, depending on the
unit.
c. Remove the mounting bracket assemblies from the
frame, if necessary.
Accessory
Gasket
Lock Nut
Leveling Bolt
Inside surface of Inside surface of
mounting bracket mounting bracket
assembly flush with assembly flush with
inside of cutout. inside of cutout.
Form No. HCSm-0416
Bottom
of unit.
two
Mounting
Bracket
Assembly
Washer
Shipping
Screw
Installing a HCSSBF Series Hot/Cold Shelf
2. On each mounting bracket
assembly, remove
shipping screws and the
triangular shipping bracket
that was used to attach the
mounting bracket assembly
to the bottom of the hot/cold
shelf and discard.
3. attach a mounting bracket
assembly to the underside
of the prepared countertop
at each corner of the cutout.
a. align the u-shaped mounting holes on the mounting
bracket with the two pre-drilled mounting holes on the
underside of the countertop. The inside surface of the
mounting bracket should be vertically flush with the inner
surface of the countertop cutout.
b. Insert appropriate fasteners through the mounting
bracket and into appropriate anchoring devices in the
mounting holes on the underside of the countertop.
Tighten securely.
4. Install the accessory, self-adhesive gasket around the inner,
vertical surface of the countertop cutout, if available.
• The gasket should be positioned 1/4" (6 mm) below the
top surface of the countertop.
NOTE: If the accessory, self-adhesive gasket is not available,
provide a caulk backing around the inner, vertical
surface of the countertop cutout 1/4" (6 mm) below the
top surface of the countertop. This will prevent the
silicone sealant applied later in this procedure from
falling through the gap between the countertop and the
hot/cold shelf.
A i r F A i r F
Condenser coils
on back of
condensing unit.
13
INSTALLATION
the
Shipping
Bracket
l o w l o w
Countertop
Cutout
Shipping
Screw