ResMed AirFit N30i Mode D'emploi page 7

Mask setting options:
For AirSense, AirCurve or S9
Therapy Pressure:
Resistance: Drop in pressure measured (nominal)
at 50 L/min
at 100 L/min
Sound: Declared dual-number noise emission values in accordance with ISO4871:1996
and ISO3744:2010. A-weighted sound power level and A-weighted sound pressure level at
a distance of 1 m, with uncertainty of 3 dBA, are shown
Sound power level
Sound pressure level
Environmental conditions:
Operating temperature: 41°F to 104°F (5°C to 40°C)
Operating humidity: 15% to 95% non-condensing
Storage and transport temperature: -4°F to 140°F (-20°C to +60°C)
Storage and transport humidity: up to 95% non-condensing
Service life: The service life of the mask system is dependent on the intensity of usage,
maintenance, and environmental conditions to which the mask is used or stored. As this
mask system and its components are modular in nature, it is recommended that the user
maintain and inspect it on a regular basis, and replace the mask system or any
components if deemed necessary or according to the 'Visual criteria for product inspection'
in the 'Warning' section of this guide.
Note: The manufacturer reserves the right to change these specifications without notice.
Storage
Ensure that the mask is thoroughly clean and dry before storing it for any length of time.
Store the mask in a dry place out of direct sunlight.
Disposal
This mask does not contain any hazardous substances and may be disposed of with your
normal household refuse.
Reprocessing the mask between patients
Only Sleep Lab Mask (SLM) variants of the mask system are intended for multi-patient
re-use. When using between patients, these masks must be reprocessed according to
cleaning and disinfection instructions available on ResMed.com/downloads/masks.
6
AirFit N30i
Pillows
4 to 25 cm H O
2
0.4 cm H O
2
1.7 cm H O
2
24 dBA
17 dBA
AirFit P30i
Pillows
4 to 25 cm H O
2
0.4 cm H O
2
1.5 cm H O
2
21 dBA
14 dBA