Beurer MG 185 Mode D'emploi page 18

4.2 Attachments
Ball head
9
Best suited for treating large areas and large muscle groups
(e.g. the upper arm or calf).
Spiral head
10
Best suited for treating deep muscle tissue and for targeted spot massages
(e.g. on the sole of the foot).
U-shaped head
11
Best suited for treating deep muscle tissue in the lower back area (excluding the spine)
or the Achilles tendon.
Air cushion head
12
Best suited for treating sensitive tissue, such as in the neck area.
Flat head
13
Best suited for treating large areas on the entire body (e.g. the thigh).
5. INITIAL USE
5.1 Initial use
USAGE
The massage treatment must feel pleasant at all times. A slight haematoma may well occur
– this is a positive therapeutic effect as the use of the Deep Tissue Massager can selectively
encourage your blood flow. In isolated cases, areas of redness may also occur on the skin. If
you experience excessive skin irritation, stop using the Deep Tissue Massager and consult a
doctor. Depending on how tense/tight your muscles are, we recommend using the device for
approx. 10-15 minutes on the area you wish to treat (legs, shoulders, arms, neck, bottom or
back).
Before using the Deep Tissue Massager for the first time, charge it first for a minimum of 3
hours. To do so, proceed as follows:
1. Connect the supplied mains adapter to the Deep Tissue Massager. The connection for the
mains adapter is located on the bottom of the handle of the Deep Tissue Massager
2. Then insert the mains adapter into a suitable socket.
3. The battery level indicator [3] displays the current battery state. During the charging process,
the LED denoting the current battery state flashes.
Left LED flashes = Low battery state (approx. 15-30%)
Middle LED flashes = Medium battery state (approx. 30-70%)
Right LED flashes = High battery state (approx. 70-100%)
As soon as the Deep Tissue Massager is fully charged, all 3 LEDs will light up permanently.
The battery will last for approx. 5.5 hours of operation when fully charged. Charge the Deep
Tissue Massager again as soon as only one red LED flashes when operating the device.
4. Before starting the massage, you first need to choose the right attachment. Section
"5.2 Attachments" contains a list of all the attachments and what they are best suited for.
18
.
A