To Use - Beurer EM 44 Mode D'emploi

TENS Program Table
NOTES:
TENS programs 1-12 can't be customized- see below.
Electrode positions should surround the area affected by pain. In the event that groups of muscles cause pain, group the electrodes
around the affected muscles.
To relieve joint pain, surround the joint with electrodes at the front and back as well as on the left and right of the joint, if possible. The
distance between electrodes must be 2 – 6 inches (5 – 15 cm).
Figures 25 and 28 apply to knee and ankle joints.
Burst programs are suitable for all areas of application to be treated with changing signal patterns (to minimize having the area become
accustomed to the treatment).

10. To Use

NOTES:
• The device shuts off if it is not in use for two minutes (automatic shutoff). When the unit is switched on again, the LCD screen displays
the menu selection and the most recently used menu flashes.
• A short beep sounds when a valid button is pressed. Two short beeps sound when an invalid button is pressed.
• Pause the stimulation at any time by pressing the ON/OFF button. To continue, press the ON/OFF button again and reset the desired
impulse intensity.
Procedure for TENS programs 1 – 12:
1. Select a suitable program from the program tables.
2. Place the electrodes on the desired area for treatment. For positioning suggestions, see the „Positioning the Electrodes" section.
Connect the cables to the main unit. The figure on the display is to help you position the electrodes.
3. Select a program.
a. Press the ON/OFF button to switch on the device.
b. Using the UP/DOWN buttons, select the desired program and confirm your selection with the ENTER
button.
4. To return to the previous selection menu, press the MENU button. By holding down the ENTER button, you
can skip individual setting steps and start directly with the stimulation treatment.
5. At the start of a session, the impulse intensity of Ch1 and Ch2 is set to 00 by default. No impulses are
sent to the electrodes yet. Using the +/- buttons, select the desired impulse intensity (Fig. 3). The impulse
intensity of each channel can be set individually.
NOTE: If the program is in a pause phase, the intensity cannot be increased.
6. To end a session early, press the ON/OFF button.
16