Assembly; Tripod Version; Wall-Mounted Version; Connecting / Disconnecting Mains Power Supply - exonda Trockenhaube M50 Mode D'emploi

GB
ON/OFF switch
Power cable with
mains plug
28
6.

Assembly

6.1

Tripod version

Assemble the tripod version by following the assembly instructions supplied
with the ST5 tripod type. For safety reasons, the old ST3 tripod type must never
be used for the drying hood M50!
6.2

Wall-mounted version

Specialist electrical and engineering knowledge is required for the installation
of the wall-mounted version. This version must therefore only be installed by a
specialist (electrician, technician) or comparably qualified personnel, following
the applicable assembly and user instructions for the ACROBAT 2000.
7. Connecting / disconnecting mains
power supply
DANGER! Risk of electric shock
Only operate the wall-mounted version using a properly earthed protective con-
tact power socket.
The appliance (protection class II) may only be operated using a properly in-
stalled power socket. We recommend that you have the electrical circuits in
your salon protected by your electrician with a residual current circuit breaker
(maximum tripping current 30 mA).
7.1

Connecting mains power supply

• Plug the mains plug of the tripod version into a power socket.
7.2

Disconnecting mains power supply

1. Switch off appliance at ON/OFF switch.
2. After use, disconnect the mains power supply by pulling out the mains plug.
3. Wind up the mains power cable on the cable holder of the tripod so that no
one can trip over it and fall.
Assembly