Activating/Deactivating Long Hair Drying; Ending Treatment; Switching Appliance Off - exonda Trockenhaube M50 Mode D'emploi

Performing treatment
Slider
Seal
Control panel
ON/OFF switch
Mains plug
Operating lights Operating lights
Drying time
8.6

Activating/deactivating long hair drying

The seal optimises the drying result for long hair and thick rollers up to 70 mm
in diameter by releasing additional drying air in the neck area. This allows this
critical area to also be satisfactorily dried.
Activating seal
• With both hands, move the sliders of the seal backwards (towards the control
panel).
Long hair drying is activated.
Deactivating seal
• With both hands, move the sliders of the seal forwards (away from the control
panel).
Long hair drying is deactivated.
NOTE:
• In order to achieve an optimal drying result with short hair dryers or rollers
with a diameter of less than 60 mm, and to avoid too much heat / hot air on
the neck, the seal should be closed and long hair drying deactivated in this
operating mode.
8.7

Ending treatment

At the end of treatment, the operating lights and drying time display flash 10
times in quick succession. In addition, 10 signal beeps will be heard. After that,
the operating lights continue to flash very slowly as a sign that the treatment is
already complete.
NOTES:
• The temperature preset and blower setting of the previous treatment re-
main stored for optional follow-up treatment or for the subsequent treat-
ment.
• Briefly switching the ON/OFF switch OFF and ON again restarts the appli-
ance with its default settings.
8.8

Switching appliance off

1. Switch off the appliance at the ON/OFF switch.
The display for appliance settings disappears from the control panel.
2. Pull out the mains plug.
3. Clean the appliance, if necessary.
GB
31